Intercooler boot complete clamp kit for Ford 03-07 6.0L Powerstroke.
Includes:
Hot Side: 2 - 2.75", 1 - 3.25", 1 - 3.5"
Cold Side: 4 - 3.25"
*NOTE: Not recommended for stock CAC boots as they are much thinner than aftermarket.
39 Reviews Hide Reviews Show Reviews
-
Great clamps
Came with all of then for the install. Slightly wider than stock and robust. Fit the boots great and an improvement over the stock clamps.
-
Clamp Torque
When tightening to Riff Raff specified torques. some of the nuts appeared to tighten down on to the non-threaded portion of the assembly. Believe I carefully selected the correct clamp for the correct location. Also the clamps did not appear any better than the OEM. Time will tell if they hold up, the CAC boots did look like a improvement, again time will tell.
-
Work well
These are good clamps that work well
-
Turbo boot clamps
Received the clamps quick, sizes were perfect. Quality is as good or better than OEM. Very pleased!
-
Clamps
Great replacements for stock. Well made. Right sizes
-
Great replacement clamps
Must have if you get the boot kit simple installation
-
No other clamp compares.
I made a mistake a few years back and bought a set of tubes, boots, and clamps that were a sinister knockoff. I run Looney Wild and UltimateX tunes for daily drivers and routinely see boost numbers in excess of 35psi which isn't insane, but more than stock nonetheless. Nothing is more fun than blowing a boot off at 70mph on the highway while running late to drop my daughter off at school. I've done this numerous times and finally had enough. Couldnt afford to buy new boots and clamps so opted for this clamp kit. These are amazing and tough as hell. I installed them and have HAMMERED on my truck everytime I drive it trying to blow them off and they just straight up dont move. I cant wait to buy the RiffRaff boots. I would buy these again in a heartbeat. Amazing price, always amazing customer service and insanely fast shipping. Dont buy anywhere else.
-
2004 F350 Joe in San Diego
Ordered this set with my cac boots.quality clamps fit perfect. Fast shipping.
-
Don't reuse your oem clamps, buy these if you buy new boots
I tried for a long time using the factory clamps. They were just old. I got new hot side boots and hot side clamps. Maybe other folks have had luck with other clamps but I feel not just any old clamp will do. These are good quality clamps and hold everything on well. I feel they will be on there for a long time to come.






