Front ABS Grease-able Block Off Fitting for Ford Super Duty 1999-16
This ABS grease tool will allow you to maintenance your front wheel bearing on the 1999-2016 Dana 50/60 axles. It can be permanently installed for those with only rear ABS or can be used just for greasing then removed.
- 6061 Billet Aluminum
- Hard Anodized for durability
- Grease Zerk fitting included
- USA Made Viton O-ring for leak-free install
- Made In USA
- Fitment - 4x4 vehicles 1999-2016
- Sold Individually
We recommend Lithium-based, non-moly, NLGI #2, GC-LB. Mobil-1 (red) synthetic grease meets this spec, and is commonly available. Your model may vary so confirm what is needed before proceeding.
*NOTE: Due to varying models and applications the Dana axle is in we can not guarantee fit or use other than the specific application listed. This product is sold AS IS, with no implied warranties of merchantability for fitness for a particular purpose, unless otherwise required by applicable law. Please review the full terms of sale and warranty before purchase. Your use of this product constitutes acceptance of these terms.
142 Reviews Hide Reviews Show Reviews
-
Another great RiffRaff product
Finally greased my front bearing and the humming went away. Everyone recommends Mobil 1 Synthetic. Not too hard to do. Highly recommend it to extend the longevity of the bearings.
-
FRONT END FORD BEARINGS
EXCELLENT PRODUCT...
NOT TOO DIFFICULT TO USE.
SAVED ME A $1,000 AT DEALER FOR r/r OF FRONT
WHEEL BEARINGS.
FOR A NICKEL'S WORTH OF GREASE, AND A COUPLE HOURS....I SAVED A GRAND!!!!!!!!!!
GREAT PRODUCT, WELL MANUFACTURED,WELL WORTH THE MONEY!!!!!!!!!!!!
-
High-quality part
Riffraff does it again!!!! High-quality part. A must have part/tool to service your unserviceable wheel hubs
-
Great maintenance tool
accidentally bought two but I can give one to a buddy
-
Awsome
Great job Clay, I modified mine from the originals. I removed the straight grease zirts and installed 45° ones, so the bearings can be greased without removing anything from the frontend on future servicing.
-
Sweet product and Idea!
Helped me cure a annoying squeak in the front end from the hub bearings. Worth every penny. Another great product by Clay!
-
Great Idea
I just had to replace my hubs after 280,000 miles and bought one of these fittings to keep the new hubs greased. They should last a lifetime. Great quality and looks nice.
-
Money saver
Great product that saves you a lot of money.
-
great useful product
This product worked great. Put new wheel bearings in and used the grease fitting to fill the new bearing with grease with ease and no mess. Worth every dime.
