Front ABS Grease-able Block Off Fitting for Ford Super Duty 1999-16
This ABS grease tool will allow you to maintenance your front wheel bearing on the 1999-2016 Dana 50/60 axles. It can be permanently installed for those with only rear ABS or can be used just for greasing then removed.
- 6061 Billet Aluminum
- Hard Anodized for durability
- Grease Zerk fitting included
- USA Made Viton O-ring for leak-free install
- Made In USA
- Fitment - 4x4 vehicles 1999-2016
- Sold Individually
We recommend Lithium-based, non-moly, NLGI #2, GC-LB. Mobil-1 (red) synthetic grease meets this spec, and is commonly available. Your model may vary so confirm what is needed before proceeding.
*NOTE: Due to varying models and applications the Dana axle is in we can not guarantee fit or use other than the specific application listed. This product is sold AS IS, with no implied warranties of merchantability for fitness for a particular purpose, unless otherwise required by applicable law. Please review the full terms of sale and warranty before purchase. Your use of this product constitutes acceptance of these terms.
146 Reviews Hide Reviews Show Reviews
-
Sweet product and Idea!
Helped me cure a annoying squeak in the front end from the hub bearings. Worth every penny. Another great product by Clay!
-
Great Idea
I just had to replace my hubs after 280,000 miles and bought one of these fittings to keep the new hubs greased. They should last a lifetime. Great quality and looks nice.
-
Money saver
Great product that saves you a lot of money.
-
great useful product
This product worked great. Put new wheel bearings in and used the grease fitting to fill the new bearing with grease with ease and no mess. Worth every dime.
-
Great piece, a must have
Great product, we'll machined. A must have for super duty owners to grease front wheel hubs. Great product!
-
ABS grease fitting
excellent product well machined and a great finish to
only down side is it needs a pin hole in it to release the pressure that builds up inside as you pump grease into it, when you remove the fitting the pressure "blows" some of the grease out. -
Awesome product
It is a very simple but awesome and effective product
-
Slick piece
Putting SD axles in an OBS, so ABS wasn't going to be functional anyways. Needed something to plug the ABS hole, and knowing this was available ahead of time was a win win. Looks good, dont know if they will extend life of the bearing but it's much cleaner than a cut ABS wire.
-
great way to be able to service your bearings
Had both unitbears go out so I gave riffraff a call and ordered these up. As always they show up in a few days and I was able to throw the new abs unitbears in and was able to grease them now. They where machined very well and went right into place with no problems.
