Diamond Eye 3" Aluminized 2 Piece Downpipe

Part Number:
122004

Manufacturer:

$86.94

Diamond Eye 3" Aluminized 2 Piece Downpipe 7.3 Powerstroke 94-97 Ford - 122004

1994, 1995, 1996 & EARLY 1997 - FORD 7.3L POWERSTROKE DIESEL F250/F350 - 3" ALUMINIZED - PERFORMANCE DIESEL EXHAUST - 2 PIECE DOWN PIPE KIT 

Write a Review

25 Reviews Hide Reviews Show Reviews

  • 5
    3in Diamond eye downpipw

    Posted by Brandon on Jul 26th 2018

    Excellent fit, easy install. Took an hour or so to get it installed. Quality product and fast shipping!

  • 4
    Easy to install, 3" exhaust.

    Posted by Unknown on Aug 17th 2017

    The product is awesome... exactly what they describe.

  • 5
    Best bang for your buck

    Posted by Tony Trevino on Feb 21st 2017

    The most difficult part of this install was removal of the factory "Cobra" I dropped the rear of my trans to gain access to remove it and to add some clearance to the firewall. Slid right in without any issues. I did move the cat hanger back 1.5 inches.

  • 5
    5 star one trimmed

    Posted by Bill McDonald on Feb 1st 2017

    Tip: cut 1-1/2" from end of upper pipe and it will install much easier and still have plenty of insertion length into lower pipe. Get a band clamp instead of using "muffler clamp" provided and pipe will come apart easier.

  • 5
    Looks Good

    Posted by Mike Tankersley on Jan 23rd 2017

    I have not installed it yet, but it looks good.

  • 3
    Good for the money

    Posted by Unknown on Jan 9th 2017

    Over all I am pleased with this product. It does take some work to get it to fit. Like mentioned by other buyers the firewall did need to be clearanced which would have to be done no matter what pipe is installed. I did have fit issues to the stock exhaust. The new down pipe was about four inches longer and the exhust would not move aft far enough to bolt up. Had to remove cat and install a delete pipe.

  • 4
    improved flow?

    Posted by Unknown on Jan 2nd 2017

    goes on pretty easy, all the sources on line say this and that, I actually had to rent a porta power to push out my cab, could not do it with a six foot bar.
    I filled the old piece with water and measured it. filled the new pieces held together by tape with water and measured volume, essentially the same. any advantage must be that path is smooth and round

  • 4
    Good bang for your buck

    Posted by Unknown on Aug 20th 2016

    Riffraff had this and many other products delivered to my house in a few short days, and the quality is worth it. My 3 inch downpipe does everything I need. Reason for the 4 stars is that the welds on mine weren't the greatest. They will definitely do the job, but they are not tig welded. Rather, they are mig welded, and have a lot of undercut. However, the welds are still deep enough that I expect this to last quite a while. As for installation, cut the stock downpipe out, and push the firewall/tranny tunnel out. I got mine to fit by running a 6ft length of 1in square tubing inside, and just pulling as hard as i could. Fit great. Id buy again

  • 5
    fit perfectly

    Posted by Unknown on Jul 7th 2016

    can't go wrong