Air Intake Heater Plug Code Eliminator for Ford 7.3L 99.5-03
- Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
- The harness, used in conjunction with the AIH plug will stop the PCM from throwing the P0541 code "Intake Air Heater Relay 1 Low".
- More than just a wire!
- Easy to install.
- Use it when you remove the AIH.
- Built for exact fit.
ALL YOU NEED TO DO IS REMOVE THE EXISTING WIRE FROM THE SOLENOID, THEN HOOK UP THIS WIRE AND RUN THE OTHER END TO GROUND.
134 Reviews Hide Reviews Show Reviews
-
Works
No codes, so it is doing its job. Also attached to an A/C compressor mounting bolt.
-
AIH code eliminator
Good product and easy installation
-
Worsl awesome.
Deleted my AIH, and didn't want a code. This did the job.
Hooks up to the "hot" side of the solenoid, and goes to a ground. It literally replaced the AIH + service wire. I grounded mine the the bracket in front of the fuel bowl. -
Works
Easy to install no code
-
Works as described
Quick easy install and nave not seen the code come back since it was installed.
-
Factory fit
It really isn't needed as long as the blue wire is still connected so I haven't put it on. But I didn't know that and have just in case.
-
Great quality easy install!
The code eliminator wire was easy to install and looks clean. I had to message riffraff to ask if i had to leave the blue wire on the solenoid or not as its not in any instructions. The answer was yes. So the response time is great too! Thanks
-
Simple and nice
Simple 3 min install, and does the job. Fast shipping.
-
Not happy
Apparently you can't bend this product it breaks the resistor wire it would be good if they tell you that in the lack of instructions
