Air Intake Heater Plug Code Eliminator for Ford 7.3L 99.5-03
- Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
- The harness, used in conjunction with the AIH plug will stop the PCM from throwing the P0541 code "Intake Air Heater Relay 1 Low".
- More than just a wire!
- Easy to install.
- Use it when you remove the AIH.
- Built for exact fit.
ALL YOU NEED TO DO IS REMOVE THE EXISTING WIRE FROM THE SOLENOID, THEN HOOK UP THIS WIRE AND RUN THE OTHER END TO GROUND.
135 Reviews Hide Reviews Show Reviews
-
Not happy
Apparently you can't bend this product it breaks the resistor wire it would be good if they tell you that in the lack of instructions
-
Works great
Bought it because I didn't want a code. Ugly but works great it's hidden in the engine pretty well so no one will see it easily.
-
it works
work perfect thanks
-
AIH Delete code eliminator
Works like it says & very easy to install. I was a little disappointed that it did not come with the wire cover/wrap as shown. Standard wire with heat shrink over resistor & connectors. It was very easy for me to cover the wire with wire wrap and seal it on the ends with heat shrink prior to installation for that professional look. Had my truck smoged a few days after installation and no codes or issues.
-
works as intended
works as intended. live up north where all parameters are met to turn on the AIH and this eliminates the soft fault. bolted it to the air compressor bolt. little tip, place a washer in between to stop the wire from twisting when tightening.
-
Great product
Works like it says and is easy to install.
-
Instructions confusing, product great
I'm new to 7.3s, and the instructions left some to be desired for my experience. I ended up having to double check on a forum to be sure. Otherwise, excellent product.
-
Easy to installl
This unit was easy to install, be sure to purchase it when you purchase the intake heater delete plug or you will get the DCT code...if you don't like hsving DTC's?
-
Prevents AIH codes
I installed it at the same time as a AIH plug. Very simple install; I wired it to one of the mounting bolts on the AC compressor. Never have had a code related to AIH.
