Air Intake Heater Plug Code Eliminator for Ford 7.3L 99.5-03
- Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
- The harness, used in conjunction with the AIH plug will stop the PCM from throwing the P0541 code "Intake Air Heater Relay 1 Low".
- More than just a wire!
- Easy to install.
- Use it when you remove the AIH.
- Built for exact fit.
ALL YOU NEED TO DO IS REMOVE THE EXISTING WIRE FROM THE SOLENOID, THEN HOOK UP THIS WIRE AND RUN THE OTHER END TO GROUND.
135 Reviews Hide Reviews Show Reviews
-
Wire
Took care of the soft code, felt like it would break if bent too much
-
Great!!
Installed along with plug, no check engine light!! installs on relay where intake heater positive wire went and to ground.
-
No codes
Easy install and eliminated the soft code.
-
AIH Code Eliminator
It works! Even on my California truck. I should have bought this part years ago instead of putting that stupid heater back in then clearing the code to get smog checked every 2-years..
-
The Fix
Fixed my CK engine light from coming on again after Superchips Tune
-
Clean and functional
Part works great and is cleaner then the map sensor line tie in
-
works great
better part not made
-
No Service Engine Light
Must Have....for No Codes
-
No Code!
A must have for the AIH delete. Leave blue wire on, remove factory wires to AIH. Ground to AC mounting bolt. Very easy and clean.
