HPOP Rear Plate O-ring Seal

Part Number:
GZ-8-005

Manufacturer:

$4.35
$3.80
(You save $0.54 )

HPOP Rear Plate O-ring Seal 

This is the only sealing o-ring that is located behind the large disk and snap ring. 1994-2003
 
Please Note: A leak or seeping o-ring in this locataion is a very uncommon leak but it can happen. Before you order this o-ring, make sure that your leak does not originate from one of the discharge hoses, rear plug or non-serviceable plug and the oil has been pushed back to the snap ring lip from air flow over the HPOP. 
 
INSTALLATION: If you are going to replace this O-ring, the pump must be removed from the engine bay. Attempting to compress this O-ring enough to reinstall the retaining c-clip by hand will cause the O-ring to slip into the c-clip groove. When you attempt to straighten out the plate you can easily cut the O-ring and it will continue to leak.

To properly compress the O-ring, use a large 8" c-clamp with one end on the pump shaft, the other centered in the rear plate. By gently tightening the c-clamp, you can evenly compress the O-ring enough to reinstall the c-clip without tipping the rear plate. Make sure that the c-clip if fully seated in its slot to avoid it blowing out while operating.

On the 1999 - 2003 pumps, the fuel bowl will also have to be removed so pick up a fuel bowl reseal kit that contains the 4 hard line sleeves that seal the hard lines to the fuel bowl. The sleeves are not re-usable.
Write a Review

2 Reviews Hide Reviews Show Reviews

  • 5
    HPOP Rear O-ring Seal

    Posted by troy Hitchcock on Jan 19th 2023

    the product was good and the information on installation was excellent.

  • 5
    Saved me $800

    Posted by Jon on Mar 10th 2022

    Was ready to replace my hpop but got the o-ring installed and so far no leaks.