Garrett Compressor Housing Outlet O-ring 94.5-Early 99
This o-ring is a genuine Garrett replacement for the Compressor Housing Outlet on all 94.5-Early 99 Powerstroke. This is an upgraded Viton oring to replace the stock square Buna oring.
F4TZ-9E436-A
27 Reviews Hide Reviews Show Reviews
-
Good fit, fast shipping.
Replaced when putting an e99 spyder and intercooler on an OBS Powerstroke and actually picked up a couple psi of boost. Must have had a leak somewhere. Fit was good and shipping was fast.
-
REPLACED ONE I DID NOT HAVE!!!!
After taking off my y-pipe from the turbo I realized there was NO O-RING!!!!!
I replaced the boots from y pipe to mainfold with the riffraff boots. Went on excellent! Awesome quality boots too.
Next I put some lube on the o ring and tightened down the band.
HUGE DIFFERENCE!!! Much more quiet and more power as well!!! Awesome!!! -
Quality replacement O=ring
Like the title says, Riff Raff always supplies quality parts with fast reliable shipping. Thanks Riff Raff
-
great fit
fit great on my y pipe. It was a little hard to keep in place while sticking the y pipe on. with a little dab of silicone it held into place.
-
Can't be beat
OEM Parts with Riffraff support and prices. What's not to like?
-
broke old one
worked just like it should no complaints, thanks riffraff :)
-
Bought Just in Case
Bought this when doing my boots just in case it was needed. My old one was fine so I didn't change it out. One thing to note was my old one was a square ring.
-
easy replacement for that shot O-Ring
Easy to install and perfect fit! Nice product
-
Perfect fit
Not much to say about a gasket. It fit perfect and high quality. I would buy it again if needed.






