Front ABS Grease-able Block Off Fitting for Ford Super Duty 1999-16
This ABS grease tool will allow you to maintenance your front wheel bearing on the 1999-2016 Dana 50/60 axles. It can be permanently installed for those with only rear ABS or can be used just for greasing then removed.
- 6061 Billet Aluminum
- Hard Anodized for durability
- Grease Zerk fitting included
- USA Made Viton O-ring for leak-free install
- Made In USA
- Fitment - 4x4 vehicles 1999-2016
- Sold Individually
We recommend Lithium-based, non-moly, NLGI #2, GC-LB. Mobil-1 (red) synthetic grease meets this spec, and is commonly available. Your model may vary so confirm what is needed before proceeding.
*NOTE: Due to varying models and applications the Dana axle is in we can not guarantee fit or use other than the specific application listed. This product is sold AS IS, with no implied warranties of merchantability for fitness for a particular purpose, unless otherwise required by applicable law. Please review the full terms of sale and warranty before purchase. Your use of this product constitutes acceptance of these terms.
142 Reviews Hide Reviews Show Reviews
-
Everyone, I Mean EVERYONE Needs This!
Nice to be able to grease the wheel bearings/unit bearings, when everyone claims they are "Not Serviceable"! How bout it only took about 10 minutes to remove the wheel, ABS sensor, connect this fitting, grease, remove fitting, and reassemble!!! Luv Riffraff Products!
-
Lube your front wheel bearings
Good idea and works great. Well made.
-
abs fitting
easy to use and did the job. definitely worth it.
-
Brilliant
Awesome product. Great design
-
Couldn't be happier
Works great, approx 25 pumps to get grease throughout the bearings... Fantastic product...
-
It works
I saw this while browsing Riffraff. After burning up a bearing, rotor & caliper a few years back I have always worried "when is the next bearing failure" Well not now, this little gizmo works perfect and a surprising amount of grease is allowed to enter. You will need to remove your caliper assembly and put it up onto your leaf spring nearby, then pull off your rotor to get to the sensor. I took apart my hub while I was there and greased up my needle bearings too. Nice product, highly recommended!
-
Perfect answer
Was going to make my own gizmo, then heard about this. It makes the job a cinch. Perfect fit quality build, very happy customer. Just used it today, made the job literally 3 minutes! Highly recommend this.
-
Perfect
So simple and works perfect. Definitely worth every penny. Telling everyone I know with a super duty about it
-
Works Perfectly
I purchased this not knowing if it would work on my 2008 F-350 SD, 4x4 with manual hubs. and YES, it works perfectly. the hold down screw from the ABS sensor kept it in place while I pumped the hub full of grease.
