Bilstein 5100 Rear Shock for 1999-2004 F-250/F-350 with 2-4" Lift
Nov 19th 2026
There is a reason the Bilstein 5100 has long been one of the go-to shocks for lifted diesel trucks. It’s not built to give you the softest possible ride. It’s built to perform. It’s built to make that heavy truck feel more planted and controlled.
That’s why we carry the Bilstein 5100 Rear Shock, 24-062466, for 1999-2004 F-250 and F-350 4WD trucks with approximately 2-4 inches of rear lift.
Check it out: https://www.riffraffdiesel.com/bilstein-5100-series-shock-absorber-rear-2-4/
Check out the full Bilstein Shock line: https://www.riffraffdiesel.com/brands/Bilstein.html

What makes the Bilstein 5100 different?
The 5100 uses a 46mm high-pressure monotube design with “digressive deflective-disc valving.” Fancy words for a setup that builds damping force quickly during slower suspension movements, helping control body roll, brake dive, trailer movement, and the extra bounce that shows up when a heavy truck gets unsettled.

In our experience, 5100-equipped trucks feel tighter, settle faster after bumps, and became more stable while towing. That firmer feel can make small bumps more noticeable at low speed, but it is also what gives the shock its controlled feel under load.

Better heat control
As shocks heat up, the oil gets thin and aerated, and their performance fades. For heavy trucks, this issue is even more impactful as the shocks are constantly trying to control heavy loads, often on rough terrain. The 5100’s monotube design separates the oil and nitrogen with a floating piston, helping reduce aeration and fade as the shock gets hot. The large single-tube body also transfers heat more efficiently than a basic twin-tube shock.

Vehicle-specific tuning
Bilstein tunes 5100 applications for the actual vehicle rather than using one generic valving package across everything. Their testing accounts for vehicle weight, loaded and unloaded use, towing, and suspension characteristics.
MotorTrend has even highlighted that this application-specific tuning as one of the biggest reasons Bilstein is a top contender in the truck and SUV shock market.
Key specs
- Fits 1999-2004 Ford F-250/F-350 4WD
- Rear position
- Designed for approximately 2-4" lift
- Bilstein part number 24-062466
- 46mm monotube body
- High-pressure gas charged
- Digressive deflective-disc valving
- Extended length: 32.01"
- Collapsed length: 20.28"
- Approximately 11.73" of travel
- Zinc-plated steel body
- No external reservoir
- Sold individually, 2 required per truck
What should you expect?
If your current shocks are worn out, expect the rear of the truck to settle quicker after bumps, move around less in corners, and feel more planted with weight behind it.
Do not expect a soft, floaty ride. The 5100 has a firmer, more connected feel, which is exactly why it works well on heavy trucks.
Fitment matters
Lift height does not always tell the whole story. Blocks, leaf packs, shackles, and custom suspension combinations can change the shock length you actually need.
If there is any doubt, measure eye-to-eye from the center of one mounting point to the center of the other before ordering. That’s exactly why we included shock dimensions above.
Bottom line: The Bilstein 5100 gives you a large monotube body, strong heat control, digressive valving, and vehicle-specific tuning without stepping into a much more expensive remote-reservoir shock. For a lifted Super Duty that still tows, hauls, commutes, and sees real-world roads, it is a hard combination to beat.
Read more about shocks, here: LINK






