Bilstein 4600 Front Shock Upgrades for 2000-2005 Ford Excursion 4WD

Bilstein 4600 Front Shock Upgrades for 2000-2005 Ford Excursion 4WD

Nov 13th 2026

A Ford Excursion is a lot of truck to control, especially once the factory shocks have some miles on them. If yours feels floaty, bounces after dips, wanders more than it used to, or gets unsettled while towing, worn front shocks can make a big difference.

We carry the Bilstein B6 4600 Front Shock (24-185462) for 2000-2005 Ford Excursion 4WD applications because it is built for stock-height trucks that still need to ride well on the street, tow confidently, and handle the weight of an Excursion without turning the ride into a brick. Bilstein lists this shock for 4WD Excursions with the 5.4L, 6.8L, 7.3L diesel, and 6.0L diesel on the standard chassis.

Check them out: https://www.riffraffdiesel.com/bilstein-4600-shock-absorber-excursion-4wd-front

 

Why go with the Bilstein 4600?

The 4600 uses a high-pressure gas-charged monotube design instead of the basic twin-tube construction found in many replacement shocks. Bilstein tunes each application specifically for the vehicle, which helps control body motion, improve steering feel, and keep the tires planted without giving up everyday ride comfort. So they're a good fit for Excursions for:

  • Daily driving
  • Towing and hauling
  • Highway trips
  • Occasional dirt-road or light off-road use
  • Replacing tired factory shocks without changing ride height

 

Key details

  • Fits 2000-2005 Ford Excursion 4WD
  • Front shock
  • Bilstein part number 24-185462
  • B6 4600 Series
  • Monotube construction
  • High-pressure gas charged
  • Designed for stock ride height / standard chassis
  • Rubber bushings
  • Protective boot included
  • Sold individually
  • Bilstein Limited Lifetime Warranty

 

4600 vs. 5100

This is worth knowing, before ordering.

The Bilstein 4600 is intended for a stock-height Excursion. If your Excursion has a suspension lift, Bilstein lists 5100-series applications for lifted 4WD trucks instead. 

What owners notice

The biggest change is usually that the Excursion suddenly rides like a car (as much as a solid axle 7700lb vehicle can at least...). Meaning that the truck feels more controlled. Less extra bounce after a dip, less float on the highway, and better body control when the weight starts moving around.

 

Install reality: simple job, heavy shock

Remove the old front shock, install the Bilstein in the factory mounts, tighten the hardware with the suspension sitting normally, then repeat on the other side. Bilstein ships these shocks pre-compressed, so expect some resistance when getting them into position.

We recommend replacing front shocks in pairs so damping stays consistent side to side.

 

Bottom line: If you’re looking for Ford Excursion shocks, Bilstein 4600 Excursion shocks, 7.3 Excursion front shocks, or 6.0 Excursion front shocks, the Bilstein 24-185462 is the stock-height front shock we’d use when the goal is better control, towing stability, and road manners without making the truck unnecessarily harsh.

Read more about shocks, here: LINK