Air Intake Heater Plug Code Eliminator for Ford 7.3L 99.5-03
- Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
- The harness, used in conjunction with the AIH plug will stop the PCM from throwing the P0541 code "Intake Air Heater Relay 1 Low".
- More than just a wire!
- Easy to install.
- Use it when you remove the AIH.
- Built for exact fit.
ALL YOU NEED TO DO IS REMOVE THE EXISTING WIRE FROM THE SOLENOID, THEN HOOK UP THIS WIRE AND RUN THE OTHER END TO GROUND.
121 Reviews Hide Reviews Show Reviews
-
IAH code eliminator
Quick and easy to install. A picture of the installed wire would be nice but is easy to figure out.
-
Excellent upgrade!
Easy installation, good quality
Riff raff rocks! -
Well made
Sure, you can make this up in the shop but at this cost point, why waste your time. This comes ready to install an as usual, is extremely well made.
-
Good product
I bought this after removing my air intake heater . No longer have check engine light or soft code. Works as described. Could be a little longer.
-
Clean truck, clean codes!
I have an extremely mint 2003 F350 and the last thing I want to see is codes on the dash. This code eliminator wire allowed me to install an AIH delete without my ECU even knowing it! 100% recommended.
-
Works
I used the AIH plug and fitting to plumb the boost gauge. This resistor works as advertised to keep the ECU from throwing a code.
-
Easy install
Don't forget to get this with AIH delete
-
Wired
Looks like a wire... not sure, looked at the instructions and hooked it up. never threw a code after my AIH restrictor plate delete.
-
AIH plug code eliminater
Fast easy install. Eliminates soft code
