Throw away the factory worm drive clamps buy these and never worry about leaks or twisting clamps again. These are used across the industry on heavy duty truck and equipment applications and is a no brainer on light duty trucks as well. Replace your factory boots while your at it and have your self a worry free install.

Clamps work great get nice and tight and seem to be well made with quality materiels.

If replacing your CAC boots, might as well do the job correctly and replace the clamps and peplums inserts as well.

These clamps fit well and hold torque nicely. They fit tightly over the boots, which made it better for installing them as they didn't slip and try to roll around the boots.

Ha to replace regular hose clamps that the previous owner had installed.

Don't even attempt to cheap out and not buy these. With stock springs tightened to the max I was blowing off the cac tubes like mad. With new riffraff tubes and clamps I'm boosting like a mad man and no movement at all.

Good clamps. Ordered the sizes listed for the hot side of my 6.0 and had to take off the nut on both sides of the intercooler boot. No biggie. Torque specs would be nice. I took them to 'gutentight' and they haven't slipped with occasional 25-30 psi boost levels.

I like these clamps they worked very well would not hesitate to buy this product again

These are much better than the factory hose clamps. A little tight to get over the thicker RiffRaff boots but not bad.