Front ABS Grease-able Block Off Fitting for Ford Super Duty 1999-16
This ABS grease tool will allow you to maintenance your front wheel bearing on the 1999-2016 Dana 50/60 axles. It can be permanently installed for those with only rear ABS or can be used just for greasing then removed.
- 6061 Billet Aluminum
- Hard Anodized for durability
- Grease Zerk fitting included
- USA Made Viton O-ring for leak-free install
- Made In USA
- Fitment - 4x4 vehicles 1999-2016
- Sold Individually
We recommend Lithium-based, non-moly, NLGI #2, GC-LB. Mobil-1 (red) synthetic grease meets this spec, and is commonly available. Your model may vary so confirm what is needed before proceeding.
*NOTE: Due to varying models and applications the Dana axle is in we can not guarantee fit or use other than the specific application listed. This product is sold AS IS, with no implied warranties of merchantability for fitness for a particular purpose, unless otherwise required by applicable law. Please review the full terms of sale and warranty before purchase. Your use of this product constitutes acceptance of these terms.
142 Reviews Hide Reviews Show Reviews
-
ABS block off fitting
Works great!Pulling the brakes and rotors takes you a little time but not that bad,if you know where this goes you have probably already been in there.I wish I had found this earlier, at 116,000 the damage is already done.
-
grease fitting
very expensive for something so small BUT IT WORKS PERFECTLY
-
grease fitting
I'm pleased with my purchase. Part seems well made. Fit into my hubs as intended and enabled me to introduce fresh grease into the otherwise sealed wheel bearing/hub unit.
-
Front ABS Grease Fitting
Great product! Good machine work!
-
Well made
I bought these and added them to brand new bearing hubs so I haven’t actually added grease through them but they seem well made and I’m sure they will make the bearings last longer. I will just make it a yearly maintenance item
-
Abs grease-able block off fitting
Worked great for greasing my Front bearings
-
FRONT ABS GREASE-ABLE BLOCK OFF FITTING 99-16
Nice piece, well made. Fit perfectly. I used these on 1998-2005 S10 Blazer 2wd front hubs. I did a spindle / hub / dual caliper upgrade on my G Body 1978 cutlass .
-
Easy to use
A lot cheaper than replacing your hub keeps the bearing grease
-
Perfect fit. Used on my 2015 F350 4x4
Worked like a champ. Highly recommended if you have a 4x4.
