Air Intake Heater Plug Code Eliminator for Ford 7.3L 99.5-03
- Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
- The harness, used in conjunction with the AIH plug will stop the PCM from throwing the P0541 code "Intake Air Heater Relay 1 Low".
- More than just a wire!
- Easy to install.
- Use it when you remove the AIH.
- Built for exact fit.
ALL YOU NEED TO DO IS REMOVE THE EXISTING WIRE FROM THE SOLENOID, THEN HOOK UP THIS WIRE AND RUN THE OTHER END TO GROUND.
134 Reviews Hide Reviews Show Reviews
-
Code eliminator
Works well. No problems.
-
worked very well
worked well not a problem at all
-
AIH code eliminator
Works perfectly. No more code
-
Air Intake Heater Plug Code Eliminator
This thing works! After trying to get my truck to pass our California Smog Testing procedures, I was at an impass with a AIH code fault. This little cord did the trick! Way better then buying a Ford part costing about 10 times as much! It definitely works.
-
works well
I wish this would have come with instructions. I don't know what ground they expect you to secure it to. connecting the end to the solenoid is simple but deciding what ground to attach to is tricky. I chose to attach to the stud that the solenoid is attached to. I had to spread the the prongs out a little to get it to fit around the stud. I have not seen an AIH code pop up since installing it.
-
AIR INTAKE HEATER PLUG CODE ELIMINATOR
Works great
-
Quick and Easy
3 minute install, no code, quick shipping.
-
Air Intake Heater Plug Code Eliminator
Used this in conjunction with the AIH Eliminator.
Installed easy, worked as described and no codes! -
Looks great
Works well
