Mag-Hytec Deep Trans Pan

Part Number:
E4OD/4R100

Manufacturer:

$365.00
$339.00
(You save $26.00 )

Mag-Hytec Deep Transmission Pan

• Deep high-capacity sump for maximum cooling 
• Magnetic drain plug 
• 303 hardware except allen head cap screws are zinc plated 
• 1/8 NPT temperature sender port 
• Finned aircraft aluminum construction 
• Requires only three allen key wrenches (included) for installation and service 
• O-rings require no gaskets or sealants  
• Holds 7.6 quarts more fluid than stock pan

Overall height 6 1/8″ 1990 to 2003 F150, F250, F350, F450, F550, F650, Trucks, Excursion, Vans, Motor homes. Excursion cross member must be moved back 1/4" All 7.3 Liter Diesels to 2003 All V10 Gas to 2004 (until 3 valve V10), 2004 Lightning and Vans -- Attention EXCURSION Owner: This application will require some modifications of the transmission cross member. There are many different ideas and each will have it’s merits and difficulties. My suggestion would be to slot the bolt holes on the cross member to allow it to move toward the rear of the truck for clearance. (NOT THE FRAME, but the cross member) The #F4R100 pan will bolt onto the transmission and then you will see how long you will need to make the slots. Some others have cut a relief in the cross member (Not my favorite idea.) Also some have ground the fins down on the pans, and cut the cross member, this is not the worst idea but again whatever will work should be looked at. This will be a project requiring tools and skills that are advanced.
Write a Review

5 Reviews Hide Reviews Show Reviews

  • 5
    MAG-HYTEC DEEP TRANNY PAN

    Posted by Erik Frates on Nov 23rd 2019

    Great product. Fantastic quality. Says what it does, does what it says... Very well. Lowered my EGTs about 200 degrees (steady average), most notably when pulling in LA traffic. I’d definitely recommend this product to anyone looking to help the performance/ longevity of their 4R100.

  • 5
    Deeeep trans pan

    Posted by 97 Crew Powerstroke on Oct 14th 2019

    First off, Looks great. Had a shifting issue with my transmission, added this pan, new filter and synthetic fluid and shifting much better. May have also worked with a regular pan but this one gives me a better piece of mind when towing 10,000+ lbs.

  • 5
    Heavy Duty!

    Posted by Ray Schork on Jun 17th 2019

    Wow is this heavy and quality USA made! Acts as a heat sink to absorb heat from the fluid. The 2 front center and 2 back get the short bolts. Diagram shows one on the side getting a short bolt but I had another on the other side requiring a short bolt. Be sure to check the thread embedment. You could have bolts that bottom out and do not seat.

  • 5
    Well made part!

    Posted by Gary loiselle on Sep 13th 2018

    Looks nice, oring seal & has a drain plug. Gathering all the extra oil necessary for the install.

  • 5
    Great produxt

    Posted by Unknown on Sep 25th 2015

    So far it's only been a week since the new pan was installed but I've only hit 160 as my high temp so far and I've pulled my corn header around from field to field great purchase and the hardware and instructions were great