Gauge Hole Plug - 2"

Part Number:
R7614

Manufacturer:

$6.07
$6.07
$5.46
(You save $0.61 )

Fit all 2" gauge holes, and allows for them to be plugged off for a clean look when not utilized. 

Write a Review

3 Reviews Hide Reviews Show Reviews

  • 3
    Gauge hole plug

    Posted by Jeff Seefried on Dec 31st 2020

    I purchased a 3 hole overhead console for possible future expansion, loading just EGT and fuel pressure gauges for now. I needed to block off the center hole. This worked for that purpose, but I had to do some filing of the outer diameter surface, and clip out some material between the snaps on each side, to get the plug to go into the existing hole in the overhead gauge pod. It's a bit too big otherwise. For the money and a little time modifying it, it works just fine.

  • 1
    Doesnt fit

    Posted by Unknown on Apr 7th 2017

    As stated in the first review, this plug does not fit the hole on the autometer pilar guage mount. I had to basically shave the sides down paper thin to get it into the hole. That being said, the face of the plug is wider than the edge of the pilar mount. Granted, it is temporary, but it would be nice if it "fit."

  • 3
    Doesn't quite fit

    Posted by Unknown on Dec 20th 2016

    Does the job to plug the hole but I had to trim it alot on the part that fits into the pod. Good thing it is just temporary cause it's not a perfect clean fit.